|
|
#include<reg51.h>
#include<intrins.h>
#define uchar unsigned char
#define uint unsigned int
//段碼
uchar code DSY_CODE[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90,0xff};
//待顯示的3位緩沖
uchar Num_Buffer[]={0,0,0};
//按鍵代碼，按鍵計數
uchar Key_Code,Key_Counts=0;
//延時
void DelayMS(uint x)
{
uchar i;
while(x--) for(i=0;i<120;i++);
}
//顯示函數
void Show_Counts_ON_DSY()
{
uchar i,j=0x01;
Num_Buffer[2]=Key_Counts/100;
Num_Buffer[1]=Key_Counts/10%10;
Num_Buffer[0]=Key_Counts%10;
for(i=0;i<3;i++)
{
j=_cror_(j,1);
P0=0xff;
P0=DSY_CODE[Num_Buffer[i]];
P2=j;
DelayMS(1);
}
}
//主程序
void main()
{
uchar i;
P0=0xff;
P1=0xff;
P2=0x00;
Key_Code=0xff;
while(1)
{
Show_Counts_ON_DSY();
P1=0xff;
Key_Code=P1;
//有鍵按下時，數碼管刷新顯示30次，該行代碼同時起到延時作用
if(Key_Code!=0xff)
for(i=0;i<30;i++) Show_Counts_ON_DSY();
switch(Key_Code)
{
case 0xfe: if(Key_Counts<255) Key_Counts++;
break;
case 0xfd: if(Key_Counts>0) Key_Counts--;
break;
case 0xfb: Key_Counts=0;
}
Key_Code=0xff;
}
}
|
|
QQ好友和群
QQ空間
騰訊微博
騰訊朋友
收藏
淘帖
頂
踩
